Ceramic Essentials Kit!

Ceramic Essentials Kit!

Regular price £52.99
Tax included. Shipping calculated at checkout.

Looking for the ultimate grab-and-go ceramic kit? 

Kit contents: 

  • Synergy Prep panel wipe 5L
  • Synergy Prep empty pro bottle
  • Synergy Lite sprayable ceramic coating 
  • Microfibre applicator for ceramics
  • 280gsm ceramic removal towel 
  • 380gsm general purpose towel (good for prep)
  • 500gsm finishing towel

All of these combined give you everything you need to get your car coated! And of course with a nice kit discount as well. 

No idea what you're doing? 

Hold your horses there! We know you usually glance over these how-to sections while uttering "yeah, yeah, yeah, I know what im doing". We know we can trust you, but at the same time, we don't. 

Before you dive into coating your car for the first time, please familiarise yourself with the below how to use section and if you need any help or advice you can contact us directly on 08000248625 via email on order@infinitywax.com or one of the best options our highly knowledgable and friendly Facebook group. 

How To Use 

Basic Application: This application method is great if you are not machine polishing the vehicle and simply want the benefits of the ceramic coating with minimal effort. 

Thoroughly wash the vehicle, ensure any tar and contamination has been removed from the bodywork. The use of Liquid Fire is also advised to assist with chemical decontamination and if required you can also use a clay bar to assist in this process. 

Dry the vehicle after the wash process, this is essential! Always open doors and dry any areas like under wing mirrors where residual water can be lurking. A handy tool for this is the BLO Air-S car drier, but a dual twist towel like the mini will also do fine. 

Next, grab some Synergy prep to ensure any residual surfactants or light contamination from the chemical decon process is completely removed. This is essential to provide a completely clean surface for the coating to bond to. work on only 1 panel at a time or a half panel if you are working on a bonnet or roof. Spray prep and gently wipe in straight lines with a new microfibre towel, excess prep will just evaporate away. A good towel for this is our general weave 380gsm

Now to apply Synergy Lite, grab an applicator such as the microfibre ceramic application block. Spray the coating 6-8 times on the block to get the new pad surface primed then begin to apply the coating in straight lines 1 panel at a time. NEVER SPRAY DIRECTLY ON THE CAR. Ensure you crosshatch the coating on application by working it up and down then side to side as this will give a better, more even bond to the surface. Now simply allow 30 secs-5 mins ideally but can be left up to 15 mins before removing the coating residue with a short pile towel like the 280gsm edgeless, you may coat more than 1 panel at a time before removing. 

Once you have coated the entire car we recommend you give it a final wipe down with a plush edgeless towel like the 500gsm ultra plush. Once you have done this you are good to go! Just remember not to wash the vehicle for 7 days after application (very important). 

Advanced Application:

Advanced application is much the same as the basic, with the addition of machine correction on the vehicle to ensure optimum results in vehicle appearance and protection. Application and curing times remain the same on corrected paintwork. 

Layering can be done as many as 20 times with Synergy Lite, this may be desirable if you are trying to hide a deep imperfection that cannot be corrected by machine. To layer simply apply the first application then remove immediately, the second layer and so on should be left for 1-3 mins before removal. repeat this process until the defect has been completely filled.